Home / Automotive / Transmission and gearshift
Precision under load, thousands of times a day.
Gearshift systems translate driver input into mechanical action through every journey of the vehicle's life. The polymer parts in that chain (lever housings, knobs, cable end fittings, pedal assemblies) must combine stiffness, wear resistance and dimensional stability with a quality feel in the driver's hand.
What the material must deliver.
Stiffness and creep resistance
Glass-reinforced PA66 holds preload and geometry in housings, brackets and pedal levers under sustained load.
Wear and friction
Consistent surface hardness and low wear for sliding and pivoting components, with lubricated options.
Oil and heat resistance
Heat-stabilised grades for transmission covers, oil pans and components near the bell housing.
Fatigue life
Cable end fittings and lever bases survive millions of load cycles without cracking or permanent set.
Our recommendation, application by application.
| Application | Our recommendation | Grades to start from | Family | Status |
|---|---|---|---|---|
| Gearshift lever housings and bases | PA66 GF30–50: stiffness and creep resistance under preload | 720C3004720C3031720C5031 | CiLON® | Ready to specify |
| Cable end fittings and rod ends | PA66 GF30 HS: fatigue life at bell-housing temperature | 720C3004 HS720C3005HS | CiLON® | Ready to specify |
| Shift knobs, bezels and covers | PA6 GF or PBT GF: feel, gloss and low warpage | 710C3001730C3001 | CiLON® ZiLITE® | Ready to specify |
| Pedal boxes and pedal levers | PA66 GF30–50: stiffness and impact for safety loads | 720C3004720C5031 | CiLON® | Ready to specify |
| Transmission oil pans and covers | PA66 GF35 HS: oil and heat resistance, flatness | 720C3005HS | CiLON® | Ready to specify |
| Bearing cages and selector components | PA66 GF25–30: wear resistance and precision | 720C3004721C3004 | CiLON® eCiLON® | Ready to specify |
| Structural pedal boxes | PA66 GF50–60: metal replacement at 40% less mass | 720C5031720C6031 | CiLON® | In development |
In production: grades in series supply for the named part. Ready to specify: validated grades with data sheets and trial quantities available; part-specific validation is run with you. In development: grades, colours and references being built with OEM and Tier-1 partners.
Design and processing notes.
Gate away from stressed bosses
Weld lines in glass-reinforced polyamide retain only part of the base strength. Position gates so weld lines fall outside cable-fitting eyes, lever pivots and pedal bosses.
Validate conditioned
PA66 stiffness and strength fall after moisture uptake. Test lever, pedal and bracket loads on parts conditioned to ISO 1110.
Design for creep
Where bolted joints carry continuous load, use compression limiters or overmoulded inserts so preload is not lost to creep.
Supplied under IATF 16949.
PPAP documentation, IMDS material data and a test certificate with every lot.
