Calco Poly Technik

Home / Materials / PiCAN®

Polycarbonate and alloys

PiCAN®

Impact strength with heat resistance.

Polycarbonate brings the highest impact strength of the engineering polymers and heat resistance well above 100 °C. PiCAN® covers unfilled and glass-reinforced PC, flame-retardant PC and the two alloys that dominate housings: PC/ABS for low-temperature toughness, flow and paintability, and PC/PBT for chemical resistance with impact.

Typical parts

Electrical enclosures and meter housingsLed luminaire housingsAppliance and business-machine housingsProtective covers and guardsAutomotive interior trim

PiCAN® grades

PC/ABS heat-deflection temperature is tuned by the PC:ABS ratio, typically 95–125 °C; the alloy is tougher at low temperature than either polymer alone.

What it offers

  • High impact strength, including at low temperature
  • High stiffness and heat resistance
  • Low overall shrinkage and high dimensional accuracy
  • Flame-retardant grades for electrical enclosures and lighting
  • Easy processing and excellent flow in PC/ABS
  • Colourable and printable; paintable PC/ABS
PiCAN®PC

750C0031F

PC, unfilled, flame retardant, impact-modified

Typical parts: Electrical enclosures, LED housings

Flame retardantNatural
PiCAN®PC

750C1031F

PC, 10% glass fibre, flame retardant

Flame retardantNatural
PiCAN®PC/ABS

760C6081F

PC/ABS alloy, flame retardant

Typical parts: Electrical enclosures, meter covers

Flame retardantDark grey
PiCAN®PC/PBT

760C3001F

PC/PBT alloy, 30% glass fibre, flame retardant

Flame retardantBlack

Design and processing notes.

Dry polycarbonate hard

Moisture above 0.02% causes splay, silver streaks and loss of impact strength. Dry at 120 °C for 3–4 hours in dehumidified air.

Design out notches

PC is notch-sensitive: use generous radii, avoid sharp internal corners and abrupt wall changes, and keep ejection stress low.

Choose the alloy by exposure

PC/ABS for flow, paint and low-temperature impact; PC/PBT where fuels, lubricants or cleaning agents contact the part.

Typical starting conditions for injection moulding.

FamilyDryingMax. moistureMelt temperatureMould temperature
PiCAN® PC120 °C, 3–4 h≤ 0.02%280–310 °C80–110 °C
PiCAN® PC/ABS100 °C, 3–4 h≤ 0.04%240–270 °C60–80 °C

Starting points for standard reinforced grades. The grade data sheet and, where issued, the product-specific processing sheet take precedence: flame-retardant, high-flow and alloy grades run in narrower windows.

Processing guidelines for every family

Try PiCAN® on your own press.

A free 25 kg trial lot compounded on production lines, and a Calco engineer at your press.

Request a sample