Calco Poly Technik

Home / Solutions / Develop a grade for my part

If the grade does not exist yet, we build it.

Most Calco grades began as a customer's requirement. Tell us the part, the specification and the process. We formulate, mould and test the compound, then prove it in your tool.

The problem

  • Close, but not right

    A catalogue grade that is nearly right still fails on one requirement: the colour, the flow, the fire rating or the cost.

  • A specification with no supplier

    An OEM material standard that no standard grade meets.

  • A colour that has to match

    A range that must read as one product, lot after lot.

The impact

A compromise on the part, a longer approval, or a launch that waits for a material.

What we can build into a compound.

Reinforcement and fillers

Glass fibre 10–60%, mineral, talc, glass beads and glass–mineral hybrids: stiffness, strength, warpage and surface finish tuned to the part.

Colour

Natural and black as standard; grey, white and colour-matched grades to customer standards with narrow colour tolerances, including light colours. Reference plaques retained for every match.

Stabilisation

Heat stabilisers for long-term thermal ageing, UV and light stabilisers for outdoor and lit parts, hydrolysis resistance for hot-water and glycol contact.

Flame retardancy

Systems developed against UL 94, glow-wire and CTI targets across polyamide, PBT, PP and PC.

Impact and toughness

Impact-modified and super-tough grades for cold-impact, drop and snap-fit requirements.

Flow and processing

High-flow grades for thin walls and long flow paths, lubricated grades for release and wear, low-emission packages for interiors.

Marking and function

Laser-markable, antistatic, conductive and EMI/RFI-shielding formulations, wear-resistant and sliding grades.

Alloys and extrusion

PBT/PET, PBT/PC, PBT/ASA, PC/ABS and PC/PBT alloys; extrusion grades for profiles, sheet and monofilament.

How a custom grade is developed.

  1. Brief

    Part drawing, specification or target properties, process and volume.

  2. Formulate

    Base polymer, reinforcement and additive package proposed against the brief.

  3. Sample

    Development lot compounded, moulded and tested in-house; data sheet issued.

  4. Trial

    Trial quantity moulded in your tool; properties confirmed on the part.

  5. Release

    Specification frozen, grade code assigned, production released with batch controls.

What to send us.

The part

A drawing or a photograph, the wall thickness and the process.

The specification

The material standard, target properties, fire and electrical ratings, colour standard.

The volume

Annual quantity and the timing of the programme.

Send us the brief.

An application engineer replies with a recommended grade, the data behind it and a free 25 kg trial lot.

Request a sample