Calco Poly Technik

Home / Automotive / Lightweighting and metal replacement

Growth programme

Structure in polyamide.

Every kilogram removed from a vehicle is range in an EV and fuel in an ICE. Highly reinforced polyamide, with 50 to 60% glass fibre, now carries loads once reserved for die-cast aluminium and pressed steel, at 30 to 50% lower mass and with brackets, channels and fixings integrated into one moulding. CiLON® GF50 and GF60 grades, and their eCiLON® equivalents, are the materials for that work.

What the material must deliver.

Mass

30–50% lighter than an aluminium die-casting at equal stiffness when the part is designed for polymer: ribs, not solid sections.

Integration

One moulding replaces a casting plus brackets, bushings and fasteners: fewer parts, fewer operations, no corrosion protection.

Stiffness and fatigue

GF50–60 polyamide gives the modulus and fatigue life structural brackets need; conditioned values are used for design.

Overmoulding

Metal inserts and compression limiters are overmoulded where bolted joints carry continuous load.

Our recommendation, application by application.

ApplicationOur recommendationGrades to start fromFamilyStatus
Engine and e-drive mount bracketsPA66 GF50–60: modulus and fatigue replacing aluminium720C5031720C6031CiLON®In development
Structural pedal boxes and brake-pedal leversPA66 GF50: stiffness and impact, integrated pivots720C5031CiLON®In development
Seat structures, frames and adjustersPA6 GF50–60, PA66 GF50: energy absorption and stiffness710C5001710C6001720C5031CiLON®In development
Oil pans, sumps and coversPA66 GF35 HS: oil resistance, stiffness, one moulding720C3005HSCiLON®Ready to specify
Front-end and radiator support bracketsPA6 GF30–40, glass–mineral hybrid: stiffness with flatness710C3001710C4001710C3301CiLON®Ready to specify
Battery-pack mounting and cross membersPA66 GF50–60, PA6 GF60: crash-load stiffness720C6031710C6031CiLON®In development
Steering-column and cross-car bracketsPA6 GF40–50: modal stiffness, integration710C4001710C5001CiLON®In development
Non-visible structural parts with recycled contentReViveX® PBT/PET GF45 with recycled content; eCiLON® PA6 GF50–60: same modulus, lower footprint740C4001-4711C5001711C6001ReViveX® eCiLON®In development

In production: grades in series supply for the named part. Ready to specify: validated grades with data sheets and trial quantities available; part-specific validation is run with you. In development: grades, colours and references being built with OEM and Tier-1 partners.

Design and development notes.

Design for polymer, then compare

A casting redrawn in polyamide gains no weight; a ribbed, topology-optimised polymer part does. CAE with fibre-orientation data is part of the development.

Creep and bolt load

Use compression limiters or overmoulded inserts under every bolt; validate clamp-load retention after thermal cycling.

Conditioned properties

Design to ISO 1110 conditioned values and validate on conditioned parts; dry-as-moulded numbers overstate stiffness.

Supplied under IATF 16949.

PPAP documentation, IMDS material data and a test certificate with every lot.

Request a sample