Calco Poly Technik

Home / Materials / HiLENE®

Polypropylene compounds

HiLENE®

Low density, chemical resistance, cost efficiency.

Polypropylene is the cost-performance benchmark: the lowest density of the structural thermoplastics, excellent resistance to solvents, detergents and electrolytes, and easy moulding. HiLENE® compounds extend it with glass fibre, talc and mineral reinforcement, chemically coupled for strength and heat-stabilised for durability, plus flame-retardant and UV-stabilised grades.

Typical parts

Appliance housings and internalsWashing-machine and air-conditioner partsAutomotive interior and hvac componentsLighting and electrical housingsHousewaresFurnitureIndustrial containers

HiLENE® grades

HiLENE® is fully recyclable; regrind can be blended with virgin material after validating the mix for the application.

What it offers

  • High strength-to-weight ratio
  • Very low density and low system cost
  • Excellent chemical and stress-crack resistance
  • Good performance in cold conditions
  • Excellent electrical properties
  • Flame-retardant, UV-stabilised, heat-stabilised and impact-modified options
  • Full colour range, including light colours
HiLENE®PP

500C1001HS

PP, 15% glass fibre, chemically coupled, heat-stabilised

Heat-stabilisedBlack
HiLENE®PP

500C2131F

PP, 20% talc filled, flame retardant

Typical parts: Appliance and E&E housings

Flame retardantNatural
HiLENE®PP

500C3131F

PP, 30% mineral filled, flame retardant

Typical parts: Appliance and E&E housings

Flame retardantNatural

Design and processing notes.

Chemically coupled glass

Coupled glass-fibre grades bond fibre to matrix and roughly double the tensile strength of uncoupled grades.

Talc and mineral for stability

Talc and mineral fillers raise stiffness and heat deflection at low cost with lower, more isotropic shrinkage.

Cool for cycle, warm for gloss

20–40 °C tools give the fastest cycles; 50–60 °C improves gloss and reduces sink on thick sections.

Typical starting conditions for injection moulding.

FamilyDryingMax. moistureMelt temperatureMould temperature
HiLENE® PPNot normally required—200–240 °C20–60 °C

Starting points for standard reinforced grades. The grade data sheet and, where issued, the product-specific processing sheet take precedence: flame-retardant, high-flow and alloy grades run in narrower windows.

Processing guidelines for every family

Try HiLENE® on your own press.

A free 25 kg trial lot compounded on production lines, and a Calco engineer at your press.

Request a sample