Calco Poly Technik

Home / Automotive / Under the hood / Cable ties

In production

Cable ties

The problem this part has to solve, what usually goes wrong, and the grade we recommend.

The problem your part has to solve.

A commodity part with the finest feature moulded in polyamide: the pawl in the head. Loop tensile strength is specified by class, the strap must wrap without cracking in a cold assembly hall, and ties routed through the engine bay must keep their strength after years at 105–125 °C. Tens of millions are moulded in 64- to 128-cavity hot-runner tools, so melt viscosity, fill consistency and cycle time decide the part cost as much as the polymer does.

Process: Injection moulding in high-cavity tools; moisture-conditioned before shipment.

What usually goes wrong

  • Brittle straps from under-conditioned or over-dried material, or the wrong viscosity for the tool
  • Pawl failure from short shots or flash in the head; flash on the strap from too-low viscosity
  • Loss of loop tensile after heat ageing on engine-bay routings
  • Strap cracking on wrapping at low ambient temperature

Our recommendation.

For general-purpose and interior routings we recommend CiLON® PA6, 710C0031A: PA6's toughness and elongation make the most forgiving strap, and its viscosity is set for high-cavity fill. For higher loop-tensile classes and higher temperature we recommend PA66, 720C0031A; for engine-bay routings specified for long-term heat ageing, PA66 HS, 720C0001HS; and for outdoor or cold-climate assembly, PA66 IM, 720C0003IM, whose impact modifier keeps the strap ductile at –40 °C. All four run on the same tools, so you can move between them as the routing changes.

Why the Calco grade works

  • Toughness and elongation for strap flexibility and hinge performance
  • Viscosity controlled lot to lot for consistent fill of the pawl in high-cavity tools
  • Heat stabilisation that holds loop tensile after ageing at engine-bay temperature
  • Impact modification for cold-climate assembly
  • Excellent processability, short cycles and high fluidity

Which grade, when.

Choose whenCalco gradeConstructionFamilyWhat it gives you
General purpose and interior routings710C0031APA6 unfilledCiLON®Toughness, elongation, cost
Higher loop-tensile class and temperature720C0031APA66 unfilledCiLON®Strength and HDT
Engine-bay routings, long-term heat ageing720C0001HSPA66 HSCiLON®Aged loop tensile
Outdoor and cold-climate assembly720C0003IMPA66 IMCiLON®Ductility at –40 °C

How we validate it with you.

Loop tensile by class

Loop tensile to IEC 62275 or your standard, dry-as-moulded, conditioned and after heat ageing.

Cold wrap

Strap wrapping and pawl engagement at –40 °C on ties conditioned to shipping moisture.

Cycle and fill on your tool

Fill balance, flash and cycle time on the customer's high-cavity tool; viscosity window agreed and held.

Try it on your own tool.

A free 25 kg trial lot compounded on production lines, and a Calco engineer at your press.

Request a sample